Solarcyl

Unvented stainless steel twin coil cylinder for solar water heating applications

Design

The Solarcyl incorporates two separate heating coils in the base and middle of the cylinder. The principle source of heat should be connected to the lower coil and the back-up heat source to the upper coil. The cylinder is fitted with bosses to accommodate solar sensor pockets to enable correct heat control on a solar system.

Capacities

Solarcyl is available in three capacities of 210, 250 and 330 litres. The units can be adapted if necessary to contain 250, 300 and 380 litres respectively by the addition of a separate expansion vessel and removal of the hot water dip pipe.

Cylinders

The Oso Solarcyl is of similar construction and design to the Oso 20 series product, further technical information also relevant to the Solarcyl can be found in the 20 series Technical Information section.

Downloads

'Solarcyl' brochure (PDF - 259 KB)

'Solarcyl' installation manual (PDF - 710 KB)